Teori
Bakgrunn
As mentioned in section 2.7 there is electromagnetic noise present when the tesla coil is used and a robust channel is needed for signal X2 because this signal is transmitted from the pulse shaper to the tesla coil driver, wich as mentioned in section 2.1 are physically located in different chassis some distance apart. For this plastic optical fibre is chosen. To further increase the robustness the signal X2 is modulated. The robustness and possible noise introduced in this channel is not discussed further as it can be treated as an isolated problem and is assumed well understood and documented in the field of electronics. A diagram of the optical channel is shown in fig. 2.13. Where CW is the carrier wave used to modulate the signal X2, PWM is the modulated signal X2. The blocks tx and rx are the optical transmitter and reciever.
Virkemåte
TBD
Versjoner
V0.0 (2009)
Changelog
- Laget av Dewald De Bruyn
Errata
- Skjematikk eksisterer ikke
V0.1 (2014)
Changelog
- Delvis reverse engineret fra 2009, delvis eget design
- Splittet ut på eget kretskort
Errata
- Bærebølgedeteksjon fungerer ikke
- Inverterbufferet dør fra tid til annen
V1.0
Release: 2017-03-16
Changelog
- Bakplanifisert
- Flyttet optisk plugg til eget kort
- Lagt til buffere før filterne
- Lagt til testpunkter
Errata
- Bærebølgedeteksjon fungerer ikke
- Statusleds oppfører seg rart muligens relatert til bærebølgedeteksjonworkaround
Produserte kort
SN | V | Visuell sjekk | Demodulator | Bærebølgedeteksjon | Interrupt LED | Status LED | Plassering | Kommentar | ||||
---|---|---|---|---|---|---|---|---|---|---|---|---|
1 | 1.0 | TK500 SN:01 | Hacket til delvis bærebølgedeteksjon | |||||||||
2 | 1.0 | TK500 SN:02 | ||||||||||