En liten, hurtig roterende søylebor egnet til boring i PCBer (glassfiber). Borene er svert tynne (0.5-1.0 mm) og knekker lett, så vær forsiktig!

Instructions

Protective Equipment

Mandatory

• Eye protection

Safe Usage

In terms of personal safety, the important thing is to wear safety goggles. As long as that is in place, the worst case realistic scenario (the drill breaks) can only give minor scratches (also keep your fingers away from the drill area). However, the equipment is expensive and fragile, so please also follow the rest of these guidelines to make sure that you do not damage it.

• Make sure the workpiece/PCB does not move during drilling
• Do not re-drill a hole
• Do not try to expand an already-drilled hole to a larger diameter, this will break the drill. You can attempt to use the drill

Tips

• After doing a test hole near the edge of the PCB, you can adjust the lamp on the drill to project its crosshairs accurately (The room must be more or less dark to see it). Then you can use the crosshairs to drill accurately.