You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

An RGA is in many ways the multimeter of the vacuum world, capable of extremely sensitive, mass selective detection of gasses down to partial pressures sometimes reaching below 1e-14 mBar. Basically, it is able to detect and identify any gasses present in the vacuum system it is installed in and can be used for highly sensitive detection of leaks, contaminates of all types and process gasses. If for example there is a major air leak, strong nitrogen  (m/z=28) and oxygen (m/z=32) lines will be present. To find the leak usually either helium (m/z=4) or Isopropanol (m/z=60.01 plus smaller fragments) may be sprayed around suspect connections, and whenever the leak is struck these mass/charge lines will see a sharp rise. RGA software often has built in modes for auditory signalling to aid in leak detection.

Most RGA's are designed to be permanently mounted to their chamber and operate as in-situ diagnostic tools. They are usually Quadrupole Mass analyzers with an electron multiplier detector, and most of the time they rely on the chamber's pumps to reach high enough vacuums to begin operations, usually around 1e-4 mBar or better. Some are however more standalone units,


Pfeiffer Omnistar GSD 301 T Manual

Pfeiffer Omnistar GSD 300 O2 Manual


BKM26253

  • 230V AC
  • Omnistar Standard Gas Inlet
  • 2m Capillary Heater
  • Possibly fast Prisma Yttriated Iridium Filament
  • 1-300 amu mass range
  • Tungsten Channeltron Detector


-



Worth Asking for:

  • Pfeiffer BG 805 203 BD; The Communications Manual for the QMS 200
  • Pfeiffer Talkstar V1 or greater; the software used for controlling the RGA



Further reading:

  • No labels